murray hallam diy aquaponics video | Projectiles Building a blow gun with laser sight

murray hallam diy aquaponics video

I thought Id build a blow dart gun with a laser sight.

It turned out to be a total success.

It works well, and is much more fun than regular darts of the non-blown variety.

I started with a couple of pins, some string, some cotton, and a thin pipe. A broken car aerial works well, so does a pen casing. Even a drinking straw works at a pinch. The longer the better, and its best to avoid flexible things as your pipe. Drinking straws tend to be a little less accurate.

I started by piercing the string so I had four strings stuck to my pin.

 I taped up the strings so they wouldnt move when I started to wrap them.

This next bit is really important.

Add a loop of cotton running the length of the pin.

Take some cotton and wrap it tightly to make a binding along about a third of the length of the pin.

I also made one where I used electrical heat shrink instead of cotton binding. It worked well, and was much faster to make, but didnt look as nice as one with binding.

Trying to tie off  the end of a binding is difficult unless you have that loop we added.

To finish your binding, pass the loose end through the loop.

Then pull the back of the loop all the way back. This will draw in the lose end, and secure it by tucking it under itself... under the binding.

Thats really important string tech. As long as you plan it beforehand and add that loop its easy, but without the loop, its next to impossible.

 The end result looks something like this.

Next I took another pin and frayed the string.

Wool would work better, but I didnt have any.

When its fully frayed, it looks like this.

You can us it like this, but it was a little slow, and not very accurate.










I trimmed mine down a bit.











The point of the tail is to create drag so it flies straight, and with the sharp end up the front where it belongs.

If you have even one thin strand longer than the others it can cause trouble.

A long strand will make your dart turn off course a bit, and can also get stuck between your lip and the tube, resulting in a blowing noise but no shooting.

An easy way to trim it is to put it into the blow pipe and cut any excess with scissors.

Next, I found my container full of prototyping plastic. I explain it in this post about its possible use in making hand made fishing lures, but basically its stuff that gets soft at 65 degrees centigrade or so, and sets hard once it cools.

Next, I got hold of a laser pointer ($15 or so), then it was a simple matter of heating up some prototyping plastic, and wrapping it around both the tube, and my laser pointer.

I added three screws that sit through the plastic so I can tighten them against the laser to adjust where it points in relation to the tube. That way, its easy to adjust and make certain everything lines up properly.



I shot some video while I was sighting it. I placed the laser sighted blow dart gun in a clamp, and repeatedly shot it, and adjusted the screws to get it more accurate. A simple matter of firing, then moving the dot to the same spot as the dart hit.







Do you find information about murray hallam diy aquaponics video are you looking for? If not, below may help you find more information about the murray hallam diy aquaponics video. Thank you for visiting, have a great day.

Related Posts by Categories